-
Senior Member
Rudder Pivot Bolts
How do I tighten to the proper torque, or even tighten them at all, thru the small cutouts specified in the manual? I have the speedster tail on my SS7. I have just spent 3 hours getting the pivot bolts in and the nuts started a few turns.
Is there some neat trick, or maybe a special tool, or am I stuck enlarging the cutouts by quite a bit in order to get a small wrench in and able to make 1/8 turn? The cutouts will be ugly. Is there a good way to cover them up?
Jim
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules