Hi all;
I'm considering installing an oil thremostat on my KF IV (amphib floats) so the engine warms up faster. Any of you have any advice on this, or had any problems with their thermostat?
Thnx for any info - much appreciated.
Hi all;
I'm considering installing an oil thremostat on my KF IV (amphib floats) so the engine warms up faster. Any of you have any advice on this, or had any problems with their thermostat?
Thnx for any info - much appreciated.
Hi,
I installed one 2 years ago have had no problems. It did shorten engine warmup times.
I was hoping it would keep temps up in the winter, I think it helps but when it gets -15C taping over the oil cooler is the only way to successfully keep the temps up on my setup. hope this helps.
Kevin,
Kitfox Outback
912 ULS
Airmaster AP332CTFH-WWR70W
Summit Aircraft Wheel Skis
C-FOXW
Sorry for the dumb question, but how and where is the oil thermostat install on a 912ULS? Have heard it discussed, but never got an explanation on how to.
Thanks,
Dick B
I have one and had no problems with it, kicks in ~200 deg and works fine.
http://www.teamkitfox.com/Forums/pic...pictureid=2417
The above should be a link to my photo album showing (sort of) the install.
Dorsal ~~^~~
Series 7 - Tri-Gear
912 ULS Warp Drive
Thnx for the info & pic gents.
Though the pic shows the unit supported only by the hoses (which is pretty rigid) I did fashion a bracket from flat stock that picks up the two mounting holes and Adel clamps to the frame.
Dorsal ~~^~~
Series 7 - Tri-Gear
912 ULS Warp Drive
Can anyone tell me where to purchase an oil thermstat that can be used with the Jabiru 2200? Maybe the one for Rotax will fit?
I have one on Ebay right now that I never used.
http://www.ebay.com/itm/140779886129...#ht_500wt_1287
Mike Bentley
Model IV-1200
Jabiru 2200A #438
Rotec Aerosport LCH Heads
Ellison EFS-2 Throttle Body
Prince Prop (64x34)
My SPOT Page