On page 36 of my manual it says: "Trowel a thin fillet of adhesive inside and against the bottom sides of the trailing edge. Make sure to fill any voids between the rib capstrips, webs, and the trailing edge."

Are they saying to fill the triangle shaped space that occurs at each rib/trailing edge junction? They don't mean the entire length of the trailing edge, right? Am I filling these little voids in anticipation of the aft-most flap hanger bracket rivets passing all the way through the trailing edge? Also, doesn't that aft rivet look kind of unsightly from the bottom? Any advice and/or photos would sure help.