hello everyone,
once again i appeal to the knowledge of this forum. the base(lower) tabs on my rudder are not welded 90 degrees to the rudder. the problem this has created is that i need to remove material from the rudder stop for left rudder(to get 25 degrees), but i have to add material to the other side so that my rudder doesn't hit the elevator for a right turn. i've read the thread about john adding a bolt for adjustable rudder stops, but i only need the added material to the right side. i think the easiest solution is just bonding a piece of flat metal to the right side. suggestions?
ken
p.s. i was going to send a picture but i haven't figured out how.