I am in need of help for my alternator problem. I have a Franklin on a model V that is close to being finished but my alternator is not "alternating". It reads 0 on the amp gauge. I have a Vision Microsystem engine monitor. The alternator came on the engine and I can not find any brand or markings on it. The paperwork says to hook up the wire to the connector marked which I have done. It also says it contains an internal regulator. I have a 4 guage wire coming off the alternator thru the monitor supplied by Vision connected to my main electrical bus. The wire running to the alternator comes from the alt side of the master switch with the other side of the master switch going to ground. I do not find a ground connector on the alternator. Can anyone see an obvious flaw in my wiring? I am following the limited plans supplied.