Hi am new to fabric aircraft purchased Kitfox 3 with Cenconite 103 and Stits Aero thane whats a good patch or cement for small hole???? thanks
Hi am new to fabric aircraft purchased Kitfox 3 with Cenconite 103 and Stits Aero thane whats a good patch or cement for small hole???? thanks
Aero-Thane is going to make that one a little tougher. Where is the hole located on the plane?
Wouldn't Stewart Systems work here?
Pete
Leander, TX
Model III SN 1000
912
Grove
I think I'd stay with Stits (Poly-Fiber) products since that is what is on the plane, rather than mix and matching...
Look in the Poly-Fiber manual, I believe there is a nice bit on repairs in there. (If you don't have one, I'd suggest you should get one.)
Dave,
I went through the official Poly-Fiber procedure which included sanding through the Aerothane in the patch area, removing the coatings, gluing in the patch and restoring all the coatings. The results were good, but it took time and care not to damage the fabric.
I sent you a DM with the detailed procedure I followed.
== Paul S
for a couple of small tool punch holes ive mixed up some poly tak and poly brush and installed a dollar patch on the inside . called it good and didnt mess with disturbing the paint .
chuck
kitfox IV 1050
912ul warpdrive
flying B , yelm, wa