My next project. Anybody haul their's folded and forward?

[foxfever]

Is it better to haul the KF backward, or just easier to trailer that way?

I bought my second KF today and should be picking it up on Friday. It is backed into a hangar, folded, and on floats. I have a 4-place snowmobile trailer I'm going to haul it home on, and it would be easiest to load it frontward.

Would there be problems with the wind blowning in the wings if I do this? I have a 4 hr drive home, so maybe I would be better off spinning it around once it's on the the trailer?

Any input would be appreciated here....

[Dave S]

Aaron,

If a person is thinking about what the wind might do blowing into the open wing root - should be easy enough to duct tape some covers over the open end.

One comment - the photo does not show any wing root braces between the front spar and bottom of the fuselage - That is something you want in place to assure the wing is not damaged by wind load or bouncing on the road during the recovery trip.

Sincerely,

Dave S
KF7 Trigear

[jtpitkin06]

Depending on the trailer axle location you may want to tow forward. This will keep your center of gravity well forward of the axle. If you go backwards it can put the trailer CG aft of the axle with a negative tongue load. That condition is very unstable.

[Lion8]

Dave and John have some good points. I'd like to add a couple more if I may.
Towing forward is ok so long as you don't get into any situation where you develop a 'wing sock' situation, like opening in the fuselage or wing tips. Secure the rudder well. Secure or better yet, remove the prop. Tie the stick good to place the elevator up position for forward towing.
John mentioned the trailer cg. Good point. If this is the case, you can place enough weight forward of the axle to put 10% on the trailer hitch. (sand bags or what ever) Torsion axles ride real nice. Coil springs with shocks ride just as good if not better. I towed mine tail forward (from N.C. to N.J. on all the interstates with no problem. I used a dual axle holsclaw boat trailer I modified for the Kitfox. It has coil springs with shocks. It handles nice. Hope this helps- Tom(Lion8)

[sdemeyer]

Ha Ha, looks like the prop is already half way removed!

[akflyer]

It was designed to be hauled backwards. With the wings folded, most of the weight will transfer to the tongue of the trailer. I moved mine on a 2 place snowmachine trailer so you will not have any issues moving on a 4 place.

The rear float strut is mounted where the wing brace would normally go. You will have to modify the brace in order to use it.

If you haul it facing forwards, cover those wing roots or it will, more than likely, balloon the covering off the ribs.

[t j]

Link to trailering wing support thread with pictures.
http://forums.matronics.com/viewtopi...hlight=trailer

The home made ones work fine but if I did it again I would just break down and buy the factory ones. I trailer my kitfox back and forth to the airport each flight.

I would also take a 2 X 4, a hand saw and some ratchet straps to beef up that left gear leg attachment. Speaking from experience retrieving a crippled Kitfox.

[Dorsal]

How I moved mine (note spring loaded stool for shock and support).

[foxfever]

A lot of good info guys, thanks.

I will build my supports on site as did the fellow from the matronics list.
Thanks for the link there.

I'm hitting the road around 3:30 in the morn, friday.

Thanks for all the replies....