On the first picture of the first thread Dan B, has a carbon panel bolt on a nice round contour dashboard do you know where to get those?
On the first picture of the first thread Dan B, has a carbon panel bolt on a nice round contour dashboard do you know where to get those?
Eric Therrien
Nicolet, Qc. Ca.
In preparation.
Sorry Eric...this one slipped past me.
That molding is the handiwork of DesertFox1 (AKA Papa). There were only a hand-full of them made over 10 years ago and I was fortunate enough to find one stashed in the corner of a hanger. I believe the mold is long gone.
Dan
Dan B
Mesa, AZ
Found the mold, it needed a little work but is now ready. I'm forming
one for Mark N next week and will run a couple extra. The part is
thermoformed from a weatherable material and is not structural, it is
a trim piece. Been using this type on the SS7, works fine, but the
challenge for the model 4 part is the custom glare shield you must
fabricate.
Eric, flat pieces of carbon fiber are available from dragoplate.com.
Very nice, quite pricey.
Phil
Do you know if the Super sport come with a Dashboard of some sort? I saw some panel with a kind of sunshed arrond the panel..... is that come whit the kit or juste the aluminium panel?
Eric Therrien
Nicolet, Qc. Ca.
In preparation.
The SS7 does come with a fiberglass glare shield in addition to the aluminum panel.
Jim
Jiott is it like on this photo? and on the top is fabric?
Eric Therrien
Nicolet, Qc. Ca.
In preparation.
Fabric over fiberglass for the glare shield, you can trim it to extend over the panel about as much as you want.
Dorsal ~~^~~
Series 7 - Tri-Gear
912 ULS Warp Drive