I have a panel! Started wiring it yesterday morning and finished this morning. After power checks I pushed in the breakers and everything came up!
Now to take it all apart and get it painted...
Dave,
They are NTE Round Hole Illuminated Rocker, Square Bezel switches. LEDs come in red (54-645), amber (54-645A), green (54-645G) and blue (54-645B). They run $3.50 to just under $5 each. I get mine from arcade-electronics.com for about $3.50 each although the big stores carry them too. I like to support the little shops...
Spec sheet attached.
These switches are rated 20A at 12VDC!
I am using a dimmer as they can get pretty bright and if you plan on any night flying they might be a bit much. The dimmer I found that works with these lights is from Oznium.com. https://www.oznium.com/led-dimmer-knob
Regards
Jeff
When you hook the switch up pin 1 is 12v supply, pin 2 is the load, and pin 3 goes to the - output of the dimmer. The + output of the dimmer is not used. The Input + and - of the dimmer need to be connected to your lighting power source and ground. Be advised that this dimmer pulls power in the off state so you need to be able to isolate power from this circuit when the aircraft is not in use.
Nice thing about the dimmer is that it has an off position and has a slight resistance to rotation. Also comes with a black and a chrome knob so you can pick which you like.
Regards
Jeff
Its an MGL E-1 used to replace the old quad gauge. I'm very happy with it.
I like the white panel color. It helps me to separate the instruments when scanning across them. I noticed when I was flying the 172 with the black panel the instruments all sort of blended together and it took me a little longer to focus on one.