Show us your panel

[t j]

I was too embarrassed to post a panel picture until now. This thread started over 4 years ago so I looked back through this entire thread just to make sure I hadn't. It is interesting to see the panels getting more and more high tech ans the time goes on.

Here's the other end of the spectrum. "Hands off" during one of my first phase one flights. Note the speed. later I installed wing strut fairing and now its 85mph.

[GWright6970]

Jim Ott,
Yes... you have an excellent point, well taken... thank you!

[Kurt.A]

No Reason at all to be embarrassed! The workmanship looks great. Simple and Very effective panel without the high expense and added weight of High Tech.

[HighWing]

I too was a bit reluctant to do the deed as I still prefer round gauges and push pull circuit breakers. I mounted the IFly on a mount made to bring the screen closer to my aging eyes.

Picture one shows the panel with the doors closed.
Panel 1.jpg

Pic two shows the video camera monitor in position and the chart pocket door open.
Panel 2.jpg

[JohnB]

IT'S ALIVE, IT'S ALIVE, BWAHAHAHA!

Sorry, it's just so exciting when the electronics light up for the first time and all the smoke stays inside where it belongs.

[SkySteve]

John,
Wow!! That's BEAUTIFUL!!! We will now call you "Panel Man".

[Mcslamma]

Yes, Very sharp clean looking panel there. And Yea, it sucks when the Genie comes out cause you just can't get it to go back in!!

[Av8r_Sed]

Well done! Is it just as pretty behind the panel?