brake help needed

[HansLab]

All,

I'm working on a project with Grove attached, the brakes are still in the box, though.
Two questions:
1. the 'receiving' (that is, top of the gear) brake line is pointing backwards - is that OK? It might be more practival to have it on the frontside. The picture shows aft-to-front, you can see the (blue) cap on the brake line receiver
2. The brakes (Grove part nr 36-2 Mfg 2-64) fit with two large pins into the wheel ass'y., but they seem not to be attached! I can get things working allright, but there will never be space between the pads and the wheel, so to see.
The pic shows top-down: the top two axels are put into a bus, but they are not attached - apart from beeing held by the brake disk.

Am I dumb and not noticing something, or what?
The Grove site shows me pictures of brake systems that all have a sort of backing-plate to attach them to the axle some way.

Any reaction highly app.

[Dorsal]

some pictures would help to understand your set-up.

[cap01]

on my model IV 1050 , the brake lines go thru the fabric and attach to the gear on the aft side with a 90 degree fitting and short nipple . at the wheel ,the brake lines comes out of the gear leg with a 90 degree fitting and go aft to the top of the brakes . hope this helps

[HansLab]

It does, Chuck! But if I' not mistaken your brake is atttached to the axle, isn't it? Howcome mine is not ;-(

[N82HB]

Open the box! The answers are inside.
What part you are not thinking about is called the torque plate; it attaches to the gear through the same bolts as the axle. The brake caliper will then slide into the two holes in the torque plate. It will slide in and out of it until the brake disc is in place to hold it.

[cap01]

it kind of depends what axle you have as how the brake plate is attached . mine has grove axles , which has two mounting flanges . one to attach the axle to the gear and another for the brake plate to bolt to . i beleive you can see it in the pictures that there are two flanges . if the axle doesnt have the outbard flange then a whole different spacer setup is required to make the wheel/ brake disk fit correctly with the brake