Hi Eric,
After re-reading my post, I realize it was clear as mud. The flow of the system is trim switch (pilot/co-pilot Ray Allen G4 control sticks) to the GSA28 to the Safety Trim and out to the Kitfox trim actuator.
I've attached the schematic from Safety Trim.
Safety.jpg
I'm comfortable with the all of this. My confusion is in having multiple trim switches. Both G4 grips will have trim switches. Do the switch wires need diodes in place before they are brought together?I think I might have found the answer in a different Safety Trim product manual.
Screenshot 2023-08-06 at 11.23.41 AM.jpg
My switch wiring will go to the GSA28. If I'm reading this right, the wires from each grip trim switch can be combined and then sent to the GSA28 without the use of diodes. Do you see it the same?
Thanks for your time with this.