I've just finished covering my right wing and I noticed some large (3in diameter, 1/16 in deep) dimples in the top of laker leading edge after I applied poly brush.

There are 2 of them.

The leading edge did sort of pop in an out before covering, and was not perfectly flat. It looks like the fabric popped some of the edge in when it shrunk.

Is there anything that can be done to mitigate the dimples? I'm assuming they will show through paint?

Ideally I would fill the dimples with super fill but it is difficult to know where the dimples will form prior to shrink.

Also how can it be avoided on the left wing?