-
Senior Member
Re: 109JB's Kitfox IV rebuild
So this one finally flew. Two flight on it so far and it is running well. However, I'm not getting enough RPM. I get 5200 rpm at full throttle in level flight. From what I'm reading it really needs to be up around 5600. So, to gain 400 rpm on a 3-blade GSC wood prop, about how much pitch am I going to need to take out?
-
Re: 109JB's Kitfox IV rebuild
If it was me, I would try one degree and see what it does. This is with a 912, correct? Static rpm of about 5300 is usually a good place to be. JImChuk
-
Senior Member
Re: 109JB's Kitfox IV rebuild
Thanks Jim. Yes it is a 80 hp 912UL. I'll take out one degree and see how that goes.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules