Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser EarthX Batteries Garmin G3X Touch
Results 1 to 7 of 7

Thread: A couple of photos - questions

  1. #1
    Senior Member
    Join Date
    Feb 2012
    Location
    Tahoe
    Posts
    336

    Default A couple of photos - questions

    What are these tabs for? I started to use them for a ground location but I thought I should ask first.

    IMG_2272.jpg

    What are these tabs behind the baggage area for?

    IMG_22685.jpg

    And finally, where is the drawing V29 in the manual?

    IMG_2271.jpg
    Attached Images Attached Images

  2. #2
    Senior Member Esser's Avatar
    Join Date
    Jul 2011
    Location
    Edmonton, AB
    Posts
    2,048

    Default Re: A couple of photos - questions

    The tabs in the baggage area are if you want to extend your baggage area you have tabs there to drill into.

    V29 should be in there very first chapter of the manual under builder tips I think....

  3. #3
    N981MS's Avatar
    Join Date
    Dec 2012
    Location
    Dexter, GA
    Posts
    161

    Default Re: A couple of photos - questions

    I used the one behind the firewall to attach a support tube to the upper edge of the instrument panel near center. I am pretty sure the kit came with the support tube.
    Maxwell Duke

    Kitfox S6 IO-240 Built it (Flying since 2003)
    Maule M7-235C Sold it (liked it though)
    RV-10 IO-540 Bought it
    Zenith CH-750 Built with 7 friends (DAR Vic Syracuse)

  4. #4
    Senior Member
    Join Date
    Feb 2012
    Location
    Tahoe
    Posts
    336

    Default Re: A couple of photos - questions

    Thanks guys. I guess I will blank off the heater ports and save them just in case I install a heater later.

  5. #5
    P Morel's Avatar
    Join Date
    Jun 2008
    Location
    Locust Grove, GA
    Posts
    122

    Default Re: A couple of photos - questions

    Quote Originally Posted by TahoeTim View Post
    What are these tabs for? I started to use them for a ground location but I thought I should ask first.
    I used those tabs for exactly that. I made a bus bar for grounding and attached it between the two tabs.
    Paul Morel
    912 Speedster

  6. #6
    Senior Member jdmcbean's Avatar
    Join Date
    Jun 2008
    Location
    Homedale, ID
    Posts
    536

    Default Re: A couple of photos - questions

    "And finally, where is the drawing V29 in the manual?"


    Section G Figure G-1 would be correct.. not V29.
    John McBean
    www.kitfoxaircraft.com
    208.337.5111

    "The Sky is not the Limit... It's a Playground"

  7. #7
    Senior Member
    Join Date
    Feb 2012
    Location
    Tahoe
    Posts
    336

    Default Re: A couple of photos - questions

    Thanks. I recently received an updated build manual that I keep at home for night reading. Low and behold, the page was there. I will be able to finish up the rigging tonight.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •