Grove Gear installation for a Model IV Speedster

[Spook712]

I will trace it out on a piece of paper and post it here. Will try to get it tomorrow but may have to wait until Thurs.

Did you have the chance to trace out the plates and take measurements?

Cheers,
Tuna

[jmodguy]

Tuna
Totally forgot... I apologize.
Will stop by the hangar tomorrow and get one to measure.

[rv9ralph]

Here is the template for Grove axles. You should be able to identify the correct one based on the part number for your axle.

http://www.groveaircraft.com/axletemplate.pdf

Ralph

[Spook712]

Here is the template for Grove axles. You should be able to identify the correct one based on the part number for your axle.

http://www.groveaircraft.com/axletemplate.pdf

Ralph

Hi Ralph,

I'm looking for a template for a mounting bracket for the wheelpants on the groove gear.

Thanks,
Tuna

[jmodguy]

Tuna
Sorry for the long delay but here is a scan of the part...
It's .060 inch thick 4130 steel