-
Re: EFWD Build
Looking for the DynaVibe! The last inquirey about two weeks ago has gone unanswered. Berfore I buy a balance master, reluctantly, Im giving one last shout out in an attempt to find the DynaVibe we once had floating around. Has anybody any info on that kit? I have a shop here that can do it for $$ but I'll just do a balance master to get me in the air until I come up with a kit. Appreciate any help.
-
Re: EFWD Build
Eddie - this may be a too obvious question but have you checked with your local EAA chapter? In any event, good luck in finding one. If you can't, PM me as I should have my Balance Master still in the hangar and you are welcome to it.
-
Re: EFWD Build
Eddie I rented one for 180 and cannot find the card where I got it from. Viking rents them for 200. The one I rented was for a week so three of us used it and made it very economical. Not sure how long Viking rental is for but they have more than one.
https://www.vikingaircraftengines.co...-prop-balancer
-
Re: EFWD Build
Thanks so much you two. I discovered Viking yesterday while looking on line. It's a one week rental. I aim to check with my local EAA chapter as well. The Gyrocopter guy asked me the same thing and no, I hadn't considered it. Great advice Darrel. Thanks for the offer, I may just hit you up on that Balance Master. I noticed one mounted on one of their gyrocopters but I believe the concensus on the forum some time ago was that the Dynavibe is capable of getting the ips down below that of the Balance Master. The BM website shows it bringing ips down from .36 to .10. I recall achieving .04 with my original install using the Dynavibe and some were getting down to .02 if I recall correctly. I am shooting for those kind of numbers.
-
Re: EFWD Build
Eddie didn’t someone on the forum buy a Dynavibe to rent out again after the one wasn’t being offered again? Patey’s rent out theirs but I am guessing only locally? If your flying through Utah your welcome to my hangar to balance at?
-
Re: EFWD Build
Much appreciated Dustin. I believe I found a guy (or two) on the field that can do it for me. Possibly for what I could rent one for. No shipping fees.:D