-
Grove Gear Roll Pins
Hello Everyone
Im fixing to press my roll pins into the for points on the Aluminum Grove gear.
The holes are only 1" deep and the Roll Pins are 2" long. I take it that the Roll pins are designed to stick out of the gear 1"? Im curious why, if you care to divulge as well.
Thanks
Eddie
-
Re: Grove Gear Roll Pins
They keep gear from moving in the mounting blocks on a hard landing or if you put too much side load on the system. They should tap in fairly easily with a little ball peen hammer.
-
Re: Grove Gear Roll Pins
Thank You for the Quick Reply
There are no delays with you guys around!
Thanks again
-
Re: Grove Gear Roll Pins
You'll love the Grove gear. It's lovely.
-
Re: Grove Gear Roll Pins
Came to the point of installing the roll pins and had the same question as Eddie. This forum is such a valuable resource!
-
Re: Grove Gear Roll Pins
What size are the pins? I need to buy some.
-
Re: Grove Gear Roll Pins
Am I to take it that no-one knows the size of these pins?
-
Re: Grove Gear Roll Pins
.25X2" SS according to my SS7 manual.
Eddie