Thanx for the info
Printable View
Can someone post pictures of the hardware used for transport. I am thinking about building the braces. Any advise? And if that advise is “just buy them”, then I am good with that too.
Steve
I don’t have close up pictures but you can look one page back on the efwd build page to see my plane on the trailer.
I took 1/2” steel tube, crushed the one end and bent it. Then I drilled a hole it it and wrapped foam rubber around it. That’s the end I bolted to the wing.
On the bottom I put a straight edge from the fuselage, drew a line on the tube and cut on the line. Then I welded a piece of flat bar with a hole in it. I bolted that to the strut attach point. I think the real ones have a pin that goes through the channel at the attach point but the way I did it worked fine too and was easier to make. Cut the pipe 1/4” longer than you think. Mine ended up being short and the wing is better to flex up slightly since it’s sinking a bit from the weight than to torque it down more. Even if it is short like mine was, you can put a bunch of washers between to wing and the brace.
Hope that all makes sense.
I posted pics of the brand new travel braces I got from Kitfox someplace here in reply to someone else asking the same question. Maybe they can guide you to their thread.
I've got some pics under "loading and unloading trailer ....." sticky towards the top.