Re: Trim indicator (Dynon )
Re: Trim indicator (Dynon )
Re: Trim indicator (Dynon )
Quote:
Originally Posted by
DesertFox4
Nice panel. Very clean.
Thanks much.
Re: Trim indicator (Dynon )
Quote:
Originally Posted by
alandbrooks
Thank you, I got a Ray Allen sensor from Spruce but haven't figure it out a way to connect.
1 Attachment(s)
Re: Trim indicator (Dynon )
Here is a shot of my D180 Dynon with the trim indicator circled.
Attachment 11222
I have a Ray Allen servo controlling my trim tab. This is using the internal feedback circuitry in the unit. The white arrows show the position of the tab in it's throw, the vertical rectangle, and the green line is the position I assigned as "neutral". There is also a mark (not easily seen in the photo) that indicates a "takeoff" position.
Re: Trim indicator (Dynon )
Quote:
Originally Posted by
Av8r3400
Here is a shot of my D180 Dynon with the trim indicator circled.
Attachment 11222
I have a Ray Allen servo controlling my trim tab. This is using the internal feedback circuitry in the unit. The white arrows show the position of the tab in it's throw, the vertical rectangle, and the green line is the position I assigned as "neutral". There is also a mark (not easily seen in the photo) that indicates a "takeoff" position.
Thanks for the input.....Think I'm getting close, in my installation don't have the servo, just the Ray Allen position sensor, it has 3 wires, green, orange and blue, the EMS unit has only one or maybe two if ground is to be used. How will be the way to connect to make it work?
Re: Trim indicator (Dynon )
A photo of the trim position sensor that I purchased from Kitfox. I have not had a chance to test this yet so, I can't tell you how well it works.
http://tropicaltuba.com/Kitfox%20Project/images/599.jpg
Re: Trim indicator (Dynon )
Quote:
Originally Posted by
Tom Waid
Thanks Tom....first of all, your Web page until now, has been a great help to me in this magnificent project that I got involved 2 years ago. So thanks again.
Main issue here is if I can use the sensor I got from Spruce (Ray Allen). If not, will get another one but it will be nice to use this one cause getting stuff abroad is not easy nor cheap.
Leonardo
Re: Trim indicator (Dynon )
Thanks for the kind words and, good luck on your project.