Flaperon support Inboard end - Mk3 Kitfox
Hi from the UK,
I have a question.
The two pieces of nylon? each side which support the inboard end of the flaperon pivot (one half in the turtle deck and one on the main fuselage).
I have to replace them for my next inspection as they are cracked.
Are they bought items or are they made to a drawing/pattern?
I've looked in the parts catalogue but can't find them.
If they are made parts, is there a drawing anyone can send to me (please :))
Martin
G-BUOL
Re: Flaperon support Inboard end - Mk3 Kitfox
Just call Kitfox, they have them. I just bought some myself. They come in two halves that you need to cut down to the proper total width.
Re: Flaperon support Inboard end - Mk3 Kitfox
Thanks Jim
How much were they? in $ will do
Martin
Re: Flaperon support Inboard end - Mk3 Kitfox
The material is 1/4" UHMW.
Re: Flaperon support Inboard end - Mk3 Kitfox
Mine are way thinner than 1/4" probably 1/8"
They may have been incorrect from the start, or they may have been thickened up by Kitfox over the years I guess.
Mine are riveted in place, at 1/4" would bolting be better?
Re: Flaperon support Inboard end - Mk3 Kitfox
Forget what I said. I misunderstood the bearings you were talking about. The model 7 I built does not use those pieces.
Re: Flaperon support Inboard end - Mk3 Kitfox
I redid mine a few years ago. I used 1/8" Derlin (Acetal Copolymer) sheet ordered from Amazon. When I redid mine I hinged the lower portion to match the Model IV design to make wing folding easier. They've worked out just fine.
I have plenty of leftover material, but shipping to the UK might not be worth it.
1 Attachment(s)
Re: Flaperon support Inboard end - Mk3 Kitfox
I hope this helps. It is from the KF3 build manual. Please excuse the construction notes added.
Ralph
Attachment 11579
Re: Flaperon support Inboard end - Mk3 Kitfox
Thank you everyone for all your replies.
I'll print the build manual off and get some delrin in the UK it's easy to get.
Martin
G-BUOL