-
rotax 912 wiring
I am confused. wiring up a rotax 912 and on each ignition module I have 2 brown wires on each module. module A has a brown wire with a female connection and one with a male connection. same on module B. So which one gets connected to the mag switch? also off the coil I have a red wire and a green/redish color wire. They are not in a molex connection they are loose with male connection ends on them. Not sure what they go to either. can anyone help
-
Re: rotax 912 wiring
dalords,
Your best source of this information is the engine installation manual....these are available for specific Rotax Engines on their web site:
http://www.rotax-owner.com/support-t...engine-manuals
I am not sure how consistent the wiring ID color is over the years and between 912 engine versions - having the manual for your specific engine removes any doubt about that.
If you can turn up the original hard copy installation manual for your engine....that would be the best. :)
Sincerely,
Dave S
KF7 Trigear
912ULS Warp Drive
St Paul, MN