Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser EarthX Batteries Garmin G3X Touch

Build pics 3

  1. SDC14960
  2. SDC14859
  3. Home made braces for transport - out of 1/2 inch conduit
  4. SDC14918
  5. Moving on its own power!
  6. SDC14838
  7. SDC14840
  8. SDC14842
  9. SDC14845
  10. SDC14853
  11. SDC14781
  12. SDC14772
  13. SDC14775
  14. SDC14776
  15. SDC14778
  16. SDC14780
  17. SDC14504
  18. IVO IFA setup
  19. IVO IFA setup, was adjusted later for exact fit
  20. Put a spring in the handle and a dowel with a bolt coming out the side. Once it's flying I'll find the various flap settings and make notches for...
  21. Too cute
  22. Powered up! No smoke or fires!
  23. Brake line. Wrapped with wire loom.
  24. SDC14477
  25. SDC14478
  26. Headset jacks and fuel valve
  27. My sister did the seat cushions
  28. SDC14422
  29. SDC14300
  30. SDC14302
  31. SDC14303
  32. SDC14304
  33. SDC14226
  34. SDC14228
  35. SDC14200
  36. SDC14202
  37. SDC14211
  38. SDC14212
  39. SDC14214
  40. Intercooler manifold and dedicated exit
  41. SDC14153
  42. Dropped cowling to clear intercooler
  43. SDC14113 2
  44. SDC14114 2
  45. Seams of firewall blanket covered with 600 degree aluminum flue tape
  46. SDC14102 2
  47. SDC14057 2
  48. Finished Mount
  49. Finished Mount
  50. rubber gasket - baffle type
  51. firewall mat for heat and noise
  52. 1/2 dense foam for noise
  53. Modified old Kitfox bell crank. Just made a new bracket to hold it.
  54. Ignition coils, regulator, Boost control valve, Map sensors
  55. Brace removed and gusset added to fit oil tank in
  56. extended cowling about 2.5 inches
  57. overall progress
  58. mock up oil cooler mounting
  59. Removed right side brace to allow oil tank to fit here. Put in gusset to reinforce.
Showing photos 1 to 60 of 60