Register
Help
Remember Me?
What's New?
Activity Stream
New Group Messages
New Events
Mark Forums Read
Forum
Advanced Search
Home
Activity Stream
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
Groups
Groups
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
Today,
08:02 AM
BillCuster
started a thread
WTB Amphib floats for S7
in
Classifieds
Looking for some amphibious floats for my Kitfox. If you have rigging that's even better. I have a place in Reno, NV...
see more
0 replies | 49 view(s)
Yesterday,
03:56 PM
LetMeFly
replied to a thread
Confusion on Wing Fabric Installation
in
Kitfox general discussion
I've updated the document a bit, and gave it a "Rev A". I'll be using it as a sort of checklist to go through as I do...
see more
5 replies | 437 view(s)
Yesterday,
01:26 PM
Dusty
replied to a thread
Red cube calibration
in
Electrical/instruments/avionics
Perfect I Plan on flying in the next few days and will recalibrate based on your recommendations Thank you.
see more
2 replies | 220 view(s)
05-29-2024,
03:40 PM
desertdave
replied to a thread
FAA Releases Policy on Training in Certain Categories of Aircraft
in
Kitfox general discussion
Looking to see when my LODA expired and found this bit of good news:...
see more
13 replies | 3861 view(s)
05-29-2024,
12:01 PM
jiott
replied to a thread
Red cube calibration
in
Electrical/instruments/avionics
Dusty, Yes, you need to decrease the K factor. I have this same red cube and have been able to dial it in very...
see more
2 replies | 220 view(s)
05-28-2024,
11:13 PM
Dusty
started a thread
Red cube calibration
in
Electrical/instruments/avionics
I have an FT 60 fuel flow transducer and an MGL extreme EMS. I don't have a return line to the tank My actual fuel...
see more
2 replies | 220 view(s)
05-27-2024,
08:17 PM
Shadowrider
replied to a thread
Stalling the Elevator?
in
Kitfox general discussion
Gary its prop wash when under power. The slower you get and the steeper aoa the worse it gets. Full power, high angle...
see more
1 replies | 221 view(s)
05-27-2024,
03:05 PM
Geek
started a thread
Stalling the Elevator?
in
Kitfox general discussion
So today we started looking at some of the Phase 1 stuff using the EAA flight cards (along with trying to get me at one...
see more
1 replies | 221 view(s)
05-27-2024,
09:03 AM
BillCuster
replied to a thread
Jabiru Success?
in
Engines
Update on the Plenum. Installing the later style Plenum gave me VERY even cooling on all the even numbered cylinders. ...
see more
3 replies | 1518 view(s)
05-26-2024,
11:52 PM
Eric Page
replied to a thread
Fuel tank taps
in
Kitfox general discussion
This stuff has much more of a thick paste consistency. Their high-fill version might do the trick for you. FEDPRO...
see more
2 replies | 188 view(s)
More Activity
No More Results
No Recent Activity